“No man can live long in the taiga, without killing …”
Eric Collier, man
One of the easiest ways to fish is to kill a stick. It is used among the vegetation of the fish, which creates a splashes of water on the surface. It can be approached to a spine or head.
It should be immediately thrown ashore, as the stunned state has a limited period of time.
This is a simplest “device” (if you can call it that). In addition to fish, they can catch and frogs.
First of all we need to make the frame “trap”. Enough 15-20 twigs. It becomes a weight loss. It couldn’t slip out.
Now we need to cut as much grass as possible. Sedge is good – long and tough. But be careful – you can cut yourself! That grass will keep the fish trapped.
Lay the branches like a fan. A layer of grass. The number of trap. This is the trick – the fish swims into the trap. That is why it is a trap! Although a big fish can break through. Socks on calories and small caliber.
After laying branches. And we are not too tightly there. For dressing, you can use the same thin and flexible branches.
The result is a “bouquet” – connected to the middle. We set a trap in the gaps. This can be seen in the morning will be the fish. The trap is put “socket” to the stream. Like a funnel into which the fish should swim.
Cargo is optional – if there is no strong flow. Grass creates a sense of shelter in fish. Fry begin with joy there – and, accordingly, predatory fish hunting these fry. Lurking behind the fish can fall into the trap and get stuck.
Do not escape at the last moment. It is not necessary to spill the fish from the water.
It is not clear that it is not possible to catch it, but it can be done!
Stone labyrinth (fish trap)
This is the old Indian way. The labyrinth is laid out aground, next to the main riverbed. This is a shape of a triangle. The coastline is the coast itself. Even that nutritious fry will not slip through! The thicker the walls, the better. First, you can move on your feet. The height of the wall above the water level should be at least 5 cm. The result should be a monolithic stone line. It should not feel the flow of water.
It is necessary to make entrances. Entrances should not be deep enough, but not very wide. It will be necessary to make it. Such ditches should be 5 centimeters lower than the bottom. There may be several ditches to one input.
From the “front” side – with the flow – you can make 2-3 entrances (depending on the size of the maze). You also need to make the “rear” entrance – wider. Fish also likes to swim there against the stream. This is a kind of “funnel” of the entrance to the fish will swim.
If you can’t get out, then you can’t get out. Need to be made deeper. At the entrances, there is no need for fish.
It is easier to get the fish out. Then, most likely, she will not be frightened and will remain in place. It remains in the bundle.
The average maze can be done in 40-60 minutes alone. This is a “stationary” option. Of course, you will be caught. The best catch
Versha (fish trap)
It is woven from the willow or willow, which grows in abundance on the banks of rivers. You will find out the simplest options.
Take the twelve of them. It is necessary to distinguish by their juicy green color. It will be woven into the frame. And for the frame itself, it could be better suited. 80-150 bars are required for a normal run.
It is easy to break the leaves off. You need to keep fish in the bark.
If you’re in the middle of a frame of … apart. Simply simply simply simply simply It will be possible to adjust the length of the tops. You can just drop it down. Or vice versa – longer.
In the summer of the twilight of the twilight of the willow or in the willow or Then it will be possible to use even thick enough rods.
And we begin to weave from the bottom up. You can weave “in a braid” – First one goes over the top, then the second. They are intertwined in front of each vertical bar. As a result, they also intertwine with each other, like a pigtail. This gives you both But, let’s hope that you get out of the taiga ahead of time. When the rod ends, it is plugged into the bottom of the line.
The following is the second, and so on, up. The most difficult part is to keep a balance. If you use too thin rods – the fish can break through. Too thick – they will break when weaving. Therefore, it is better to braid the pigtail, not through the rod, but after it – it can be maintained. At the apex of the cone, you can braid the rods without the “pigtail”
When the top is woven, you can adjust and clear the bottom bars. We can’t make it anymore for you to go. The diameter of the “entrance” and the top is the same.
Now weave the “entrance” – by analogy with the top. That is, we can stick (short) rods into the bottom. The difference is that the “entrance” cone is not braided, but only about 3/4, leaving the top open. Next, cut off on the other side.
There wasn’t any kind of sharp twigs. You need to attach the “entrance” to the top. Scrape them with the same weave. So that the rods hold together the “entrance” and the top of the case. But in this case, you get the whole thing. Therefore, it is better to pull the “entrance” out of the case.
- If there is a current
- If there is no flow, you can still stand.
It is good to put it between the bushes of grass. Especially if you have already seen fish there. It can get in a trap. Without complementary foods, only predatory fish usually climb into the trap.
If you’ve settled down, you can’t make a dam of scrap materials, leaving the hole in the center. So it will be safer.
Schuchy willow root trap
Why willow? First, the willow often grows on the river bank, and secondly Too thin to use it is not necessary – they float to the surface and bend. Thick, respectively, too. Loop at the end. Now insert the self-locking loop. The loop is freely tightened.
It is better to fix the spike with the loop. But you can catch it in your hand. It begins to be too deeply, as it begins to be. It all depends on the thickness.
It is very slowly (!), So that it doesn’t get scared and doesn’t twitch. Silo pike is not usually “see” and do not leave the place. Pike, as it is known, “stands” Of course, you need to check if there is a pike in the pond.
When fishing for pike, it takes time to look around. Where can a pike stand, where can a pike be caught? Pay attention to: tree trunks lying in the water; reed and edges of wilted water-lilies; on the bottom and pits
As a rule, these are hot spots. If you are lucky, you can find a pike during a hunt (small fish jump out of the water). And this is half the luck, since pike has zhor.
In fish, there is a certain feeding time. Pikes spend their time in search of food. But the one who is fishing. If you regularly watch big pikes at this time of day. This technique increases the chance to catch a fish.
There are thickets of water lilies, shrubs and reeds, where they can be seen in the ambush. True, these places are quietly crept up and silently stepping along the shore. In the outflow of water, it is not a problem.
Scalloped Shawns. It is desirable that it should be metallic. For example, from a fork. If you want to wear it, it will help you to wear it.
The second method is more consuming. The neckline is where you can’t get it. It is very convenient to use plastic-coated forks. It is clear that in this case, it is possible to remove this covering. But anyway, it doesn’t split.
A folding knife can be a good starting material for harpoons. In addition to the main blade, a small blade can be used, a small screw driver, a small screw driver, a screw driver, a can opener, a corkscrew, etc. Fix the blade in the same way as the fork. It gives a large area of support. If you’re liking on the other hand, you’ll be able to make it out.
A good harpoon can come from a metal spoon. There are some deep notches, burrs. It should be fixed in the same way as a fork.
It can also be done with a nail.
Rod from a lighter and nettle spring
Suppose you have a lighter with flint Do not rush to throw it away! You can still come in handy. From the spring you can make a hook.
In the lighter, the two springs in the valve. It can be used to make it out. Therefore, we take a spring located in the spool. It is necessary to carefully observe the valve in the upper part. In the center of its valve, from which the flame comes out. Of course, it is necessary to remove the metal edging in advance. The spool is around the spool. Warning – the lighter must be completely empty, without gas!
It is a white plastic cylinder with a valve sticking out of it. If you’re not in it, you’ll not find it. You can pick up a knife with a knife or even teeth.
Small spring on it. Remove the ring and the spring itself. Bends hook up to the valve, and stretch it. Do not scratch! Form something more or less like a hook. Leave a few “rings” to which you will attach the “fishing line”.
It is easier to remove the fibers. Fibers on the stem go “fragments” – from leaf to leaf. Somewhere in 10 cm. Only the “film” remains. The “line” will be.
Overlap the hook – two “fragments” and the twist to secure. In the end, we’ve passed through the “fishing line” Now the hook is firmly fixed! Fragments are twisted into a lace.
Now for the first two. Though they are twisted, but the ends stick out. First we twist with one, stretching Then it is free of charge. Then we twist them together again.
Then in the same way we increase the “fishing line”. It’s not necessary to make it so you can’t get it. And above, it can be anything thick.
Length in 30 centimeters is enough. With a diameter of 8-10 mm is suitable for this. The “fishing line” on it.
It can be sharpened as a needle. It will not be a matter of how much it cleaned the pulp. We do not need it.
It is not easy to put a bait on such a hook! It is best to use those insects that are already found nearby. Well suited for example maggots – if they are there next.
If there are no materials for you, you can say, “If you’re a fish,” you can’t hold it. a float. Or wear a loose loop on your index finger.
Finally, it’s possible to use wood, fish and bird bones (it’s possible to survive!). Wooden hook up to the side. The groove for the tying fishing line. Cleaned and slightly burned to increase strength. On the sting you can not a bech. More reliable flat wooden or bone hook. From a strong branch, we chop a two-, five-centimeter wand (which depends on the size of the intended prey) a wand, which we sharpen from two sides. Circular groove for the fishing line. We put the bait on the fishing line. If you are a fish
If you want to take a large prey, it does not always justify itself. It is much easier to pick up a 2-3-kilogram. In addition, large fish often breaks off the tackle (especially fragile improvised), and it is very difficult.
Do not try to catch the fish in the water with the jerk; It is better to guard the road through the water. If you doubt that the fishing rod will stand, throw it carefully and watch it carefully. Soon the fish will stop. Do you really want to go there? When the hook is deeply swallowed, it is sharply. Sharp jerks can be very difficult. Better cut the fish and gently pull the hook. Of course, it keeps you up to the whole world.
Smoked fish without oil lamp
With giblets, salted. We make a fire and wait for it to burn out. In the meantime, we pick up alder leaves or willow leaves (these plants are abundant on the banks of rivers). There are a lot of leaves at once. The leaves, torn in such a way, are stuffed into the hand.
There are 5 cm of leaves, and there is a layer of 5-7 cm.
There is a gap between the fires and the fires. Carefully spread the foliage on top. Naturally thick smoke falls down – this is what we need. This smoke will smoke. It is a little bit more than that. And again close the foliage.
Leave for about 15 minutes. Like when cooking kebabs, flames are not allowed.
It depends on the number of parameters: wind (it depends on the season).
From the book of M.Didenko – “Russian style of survival”