To portable opadnyh airplanes is a slip made of two boards (scheme a). At one end, they are connected by ribs with a rope loop, and at the other, they are strengthened with wooden guide plates nailed to the bottom board. These boards are connected at the top by a jumper with a cord attached to it, on the free end of which a gatehouse is attached.
Breakthrough, die and mallets, opaque portable airplanes for ermine, squirrel and mole, device, operating principle, dimensions and manufacturing.
A slip guard is a narrow, long (full-length board) plank (I) with a notch at the free end. She holds the gatehouse (II) at the activated breakthrough. To increase the pressing force of the upper board, a recess is cut in it from above, into which oppression is placed – the end of the log (III). The animal, crawling between the boards, presses on the guard (I), the gatehouse (II) is twisted from under the top board, which falls down under the influence of gravity of oppression – logs (III).
From two boards, you can make a portable die. For this samogolovnogo boards are connected by flat sides together and at one end they punch a pair of holes through which they are connected with twine. The boards are placed on a stump or ground near a tree, or they drive a stake next to a fork, to which a vertically placed log is leaned against, and its end end is placed on the top board of the die, giving it proper pressure.
Details and dimensions for a skid for catching an ermine and a die for catching squirrels.
The die’s guard consists of a gatehouse – two square planks (one smooth, called a “peasant”, and the second with a ledge – “grandma”) and a guard – a long wooden rod with a square neckline at the end. To guard the dice, the “peasant” rests on the notch of the “grandmother”, in the middle they are intercepted by the square cut-out of the guard and lifting the top board of the die, between it and the base (second board) they put the guard (II) with guard (I) in disgust (scheme b, c ).
Portable hammers for fishing the Siberian mole, device, principle of operation, details, sizes and manufacturing.
Portable mallets are well known in the taiga of Western Siberia, where they hunt the Siberian mole, which is twice as much and much more careful than the European one. Moles are not caught in metal traps that are not devoid of the smell of human hands and pass around them or are clogged with earth. Therefore, commercial hunters prefer to catch Siberian moles with mullets..
For the manufacture of mole butterflies, trees with a thickness of 10-12 cm with a rotten or soft core are suitable. The trunk of such a tree is sawed into chunks 12 cm long. One third is chipped off and through this cleavage the middle is selected with a chisel chisel or chisel, turning the chunks into a wooden arch 2-3 cm thick. 6 cm are measured on the upper convex part of the arch (III) and a window is cut through 1/3 arch depth and 4 cm wide.
Details and dimensions of the mallets for catching the Siberian mole.
The convex 6-centimeter part of the arch is squeezed by a centimeter for stability of the gatehouse placed on this surface – the plank (II). The width of which can be 3-4 cm, and the length is 7 cm. One outer end of the plank is aligned with a section of the arch and paired with a flyer-guard (I) with a square neckline on the rod. At the other end of the gatehouse, which hangs a centimeter above the window, they push the crush of a gun, embedded in a splinter of oppression – logs.
In each mole, they put two such mufflers with guards, one towards the other. The mole walks into the wooden hammers without fear, pushes the guard, thereby freeing the guard-board, from which the crush jumps and presses the animal across the back to the ground.
Based on materials from the book Hunting Samolov and Unauthorized Fishing. Directory.
Gerasimov Yu. A.