A simple node is one of the simplest basic nodes. It can be used to stop a rope passing through a hole or other fastener. Such knots are the first stage for a number of other knots, starting with the reef and surgical knots, as well as the familiar bow, which is used to tie shoe laces. With a simple knot, the end of the thread is often fastened when sewing.
Easy-tying knots, simple knot, double simple, dead, cow, retainer, figure eight, bloody, docker, purpose and method of knitting.
A simple knot is a small knot-limiter. If it is tightened properly, then it will be quite difficult to untie.
The way to tie a simple knot.
Double simple knot.
Double Simple Node A sophisticated version of a simple node. It forms a thickening on the rope of a larger size, which even more reliably stops it at the hole or block. This knot can be used to fix the thread on a looser fabric.
The way to tie a double simple knot.
Dead knots are designed to have almost the same load applied to both ends of the rope at the same time. They should not be used if the load is on one side only. Especially if she will change direction. In this case, especially if the rope is slippery, the dead knot will eventually untie itself. It is convenient, for example, for the construction of temporary barriers of poles and ropes or for holding the rope through several fixed points.
The method of tying a dead knot.
The cow knot is a very simple way of attaching the rope to a ring or pole using both ends, each of which is supposed to load. These loads should be equivalent in order to prevent sliding along the knot, especially considering the fact that modern synthetic fibers are very slippery. Cow knots are often used to attach sails..
Method for tying a cow knot.
The locking assembly is based on a dead assembly. It is used to fasten one rope to another or to a pole. If the load is assumed only at one end of the rope. When you knit any kind of locking knot, immediately decide which way the load will go. Depends on which side to do the turns. The tension should go against the turns, as shown in photographs with finished knots.
The method of tying the locking assembly.
Eight is a good stopper. It forms a large “bulge” on the rope, which fixes it in front of the block or hole, and at the same time it is usually quite easy to untie it. If it is under strong tension, it will be untied with difficulty, but still better than simple knots. The most important thing in its formation is weaving to and from itself, so that a figure eight is formed. Which direction doesn’t matter.
The way to tie a knot figure eight.
Half-drawn bloody knot.
Fishermen like to use such knots to attach monofilament fishing line to hooks and swivels, because it is easy to remember and easy to tie, and it holds firmly. For thick woods it is not very suitable, but a thin cord is used in the photographs for clarity.
The method of tying a half-drawn bloody knot.
When the end is used to transfer a thicker hawser, for example, from a ship to the shore or from one bank of the river to the other, it must be attached to the cable. Docker nodes are simple, knit very quickly and, importantly, they are also quickly untied. Such nodes may not be very beautiful, but they cope with their task.
Based on materials from the book “The Big Book of Knots”.